Hot Cold Roll Laminator 110V Doubel Side Laminator Laminating Machine with 0-180℃ 110V

Introduction:<br> Small automatic laminating machine can protect printed charts, contracts and important documents, improve the level, and the laminated documents are waterproof, mildew-proof, oxidation-resistant, temper-proof and washable. It is a common tool for office printing, advertising graphics and photo studios. With the progress of technology, the functions of small film machines have been continuously improved, and the laminator can also be used for laminating flat film, mobile phone shell film, and paper art to increase income.<br><br> Features:<br> The system judges the situation automatically. If manual violation is found, the system rejects unreasonable instructions, takes over the machine, enters the full-automatic mode, and intelligently controls te machine to prevent burning.<br> One key quick control panel:<br> 1. Click the "HOT" key: automatically preheat, provide sound prompts and the constant temperature, and make a sound again.<br> 2. When the motor is stationary, if the temperature regulation exceeds the safety limit, the system identifies violations and intelligently controls them, which is very safe.<br> 3. Click the "COLD" key: disconnect the heat source and enter the cold mounting or cooling mode. The operation is simple.<br> 4.Point(EXIT) key:free hands and prevent mistakes.<br> Sound warning: quick preheating, the beep sound prompt is given after the machine is preheated;<br> Fault warning and automatic shutdown;<br> No response warning for timeout;<br> If you forget to shut down, the system will shut down automatically;<br> Easy and safe operation.<br><br> Note: This product does not contain precoating film.<br><br> Parameter:<br> Film laminating width: A3+/33cm(Length customization)<br> Paperboard thickness: 0.1-5mm(With stepless clutch)<br> Film laminating speed: 0.3-3M/minute(Nine speed transmission)<br> Power supply: 110V/60hz(Total power 600W)<br> Temperature: 0-180℃(Preheating is only 3 minutes)<br> Main machine weight: About 6kg<br><br> Hot mounting/cold mounting;single/double side:<br> Cold installation and hot installation are both "lamination" based on different classifications of laminated consumables. Therefore, the lamination includes hot lamination and cold lamination. Our small film machine not only supports the precoating of hot paste consumables BOPP and PET hot-melt adhesive, but also supports various cold paste films and self-adhesive materials. Besides hot installation on one side, the small film machine can conduct hot installation on both sides at the same time. Users should flexibly use these two consumables according to customer requirements and product compatibility characteristics. If some printing substrates do not bear high temperature, cold mounting film can be used to complete the lamination operation.<br><br> ​Item Number(120141):<br> One set of A3 Roll Laminator(110V)

• This hot cold roll laminator can ues BOPP film or crystal film,when the film is placed at the upper and lower positions, and then double-sided lamination can be completed at one time.
• The system will judge automatically. If it finds that the system refuses unreasonable instructions, it will take over the machine and enter the full-automatic mode. The intelligent control will prevent the machine from burning.
• The temperature, speed, mode of the Laminator are highlighted digital display, whether natural soft light, direct sunlight, or night, can be displayed very clearly.
• When the laminating machine is working, the cots run continuously. There is no direct friction between the rubber roller shaft and the shaft sleeve, almost no wear, and the service life is longer.
• This doubel side thermal laminator uses a connected paper feeder, always with the host, not easy to lose. When installing or changing consumables, the platform can slide and turn over along the track, without removing and falling.